Wednesday, June 22, 2011

Home Repairs

All I wanted to do was repaint the front steps. The paint was flaking. I asked Matt to sand first to get up loose paint and smooth everything. This is what happened instead:

KONICA MINOLTA DIGITAL CAMERA

And, of course, it wasn’t even this easy.

The front board tilted. Matt figured that while we were at it, might as well pull up that board and see what was causing it to tilt and bubble in the middle. He found a wood support and a jimmy. He pulled the jimmy out and thought, “Problem fixed.”

It fixed that board, but all the rest now had a gap between the floor board and the support that caused the planks to bounce. He couldn’t fit the support and jimmy back in how they were, so the rest of the boards came up.

Now came the really hard part. The cement underneath was lower in the back than at the front. So any support would be too low and create bouncing while the front would be too high and cause tilting. The picture above is actually what we came up with after mitering corners and figuring out how to support everything and make it over the hole without the supports getting too high.

Then, we find that the cement itself is too high in the front. It comes up higher than the frame. So there is still tilting of the front board.

KONICA MINOLTA DIGITAL CAMERA

That, of course, calls for more demolition.

This morning, Matt bought all new planks and got them all nailed on. He is very proud to have come up with a nice looking end result that did fix the original problem. I can now paint my front steps.

No comments: